DAVIS Solar Power Kit for Wireless Stations - Manual (Page 3)

Installation for Standard Stations Page 3
I NSTALLATION FOR S TANDARD S TATIONS
To transform a standard station, follow these steps:
1. Open the shelter door using a flat head screwdriver.
2. Remove the cover from the transmitter by pushing down on the tabs at the top until
you can remove the tabs from the slots.
3. Install the transmitter using the three #6 x 1/2” (12.5 mm) screws, as shown below.
I NSTALLING THE T RANSMITTER
4. Mount the shelter against a wall or post, on a small pipe, or on a large pipe.
CAUTION: Remember to face the solar panel south in the Northern Hemisphere (or north in the
Southern Hemisphere) for maximum sun exposure.
✦ Wall or Post
Attach the shelter to the mounting surface in the desired location using
the lag screws and 1/4" flat washers as shown below.
M OUNTING P OWER K IT ON A W ALL OR P OST
A
B
Base
Cover
#6 x 1/2" (12.5 mm)
Screws