DAVIS Solar Power Kit for Wireless Stations - Manual (Page 4)

Page 4 Solar Power Kit
✦ Small Pipe - 3/4” to 1 1/4” (19 to 31 µm)
Use the 1-1/2" U-Bolts and saddles, and the 1/4" washers and hex nuts
as shown below.
M OUNTING P OWER K IT ON A S MALL P IPE
✦ Large Pipe - 1 1/2” to 2 3/8” (38 to 60 mm)
Use the 2-1/4" U-Bolts and saddles, and the 5/16" washers and hex nuts
as shown below.
M OUNTING P OWER K IT ON A L ARGE P IPE
5. Remove and label the cables from your existing junction box and insert them into the
appropriate jacks in the transmitter.
Refer to the SensorLink manual for instructions and illustrations.
6. Secure any exposed cables with electrical tape, cable clips and/or cable ties so they do
not whip about in the wind.
7. Continue with the transmitter and receiver installation using your SensorLink manual.