DAVIS Solar Power Kit for Wireless Stations - Manual

Product # 7709
S
O L A R
P
O W E R
K
I T
F O R W I R E L E S S W E A T H E R S T A T I O N S
This manual describes how to install the Solar Power Kit for Wireless Weather
Stations. The power kit enables wireless stations to be stand-alone units that
combine transmitter and renewable power source in one weather-resistant
shelter, thereby eliminating the need to run a cable to a power outlet or to
replace batteries regularly.
This kit is designed for three applications: one, transforming an ordinary
Wireless Weather Station into a solar-powered station; two, transforming an
EZ-Mount Weather Station into a solar-powered and wireless station; and
three, transforming a standard Monitor or Wizard station into a solar-powered
and wireless station. For these last two applications, the SensorLink™ Trans-
mitter and Receiver (#7610 and #7611) must be purchased separately.
CAUTION: Please note that while we have made every attempt to design and manufacture a safe product,
Davis Instruments cannot assume liability for any injury or damage caused directly or indirectly by the
installation or use of this product.
C OMPONENTS
The Solar Power Kit includes the following components. Please be sure you
have all listed components before beginning.
Shelter
Cable
Tie
#6 x 1/2" (12.5 mm)
Screws
1/4" Flat Washers
1/4" Hex Nuts
5/16" Flat Washers
5/16" Hex Nuts
1/4" Lag Screws
2 1/4" U-Bolts
and Saddles
1 1/2" U-Bolts
and Saddles