DAVIS Wireless Wizard III & Monitor II - Manual (Page 2)

Page 2 Wireless Weather Station
T OOLS AND M ATERIALS N EEDED
In addition to the components listed above, you may need some of the follow-
ing tools and materials.
✦ Flat-Bladed Screwdriver
✦ Phillips Screwdriver
✦ Adjustable Wrench
✦ Wire Cutter or Scissors
✦ Pencil or Other Pointed Object
I NSTALLATION S TEPS
This manual takes you through the step-by-step process of installing your
weather station. These steps are indicated below, along with their page num-
bers for easy reference:
✦ Assemble and test the station, page 3
✦ Detach the extension tube, page 3
✦ Attach the anemometer, page 3
✦ Attach the wind cups, page 3
✦ Snip the cable tie in the rain collector, page 4
✦ Apply power to the console, page 4
✦ Apply power to the sensor array, page 6
✦ Check that the console is working properly, page 7
✦ Choose locations for the sensor array and console, page 7
✦ Test the proposed locations, page 8
✦ Set dip switches to control ID code and operating mode, page 9
✦ Mount the sensor array, page 11
✦ Secure the sensor array and re-apply power, page 13
✦ Mount the console, page 13
If, once installed, you encounter any problems with the station, please refer to
the troubleshooting guide on page 14.