DAVIS Wireless Wizard III & Monitor II - Manual (Page 13)

Mounting the Console Page 13
Securing the Sensor Array
After mounting the sensor array, secure the sensor array to the extension tube
as shown below.
Powering the Sensor Array
To re-apply power to the sensor array, refer to the instructions on page 6.
M OUNTING THE C ONSOLE
1. Apply power to the console using either the standard setup or the optional Weather-
Link setup (see step 5 on page 4).
2. Consult the Monitor or Wizard owner’s manual for instructions on mounting the con-
sole on a wall, desk, or shelf.
Because cordless phones may interfere with station reception, it is advisable
to keep the cordless phone’s handset and base at least 10 feet away from the
console at all times. Also, avoid positioning the console near large metal
surfaces, such as a refrigerator.
3. Consult the Monitor or Wizard owner’s manual for instructions on installing a backup
battery in the console.
Sensor
Array
Extension
Tube
Hex
Nuts
Lock
Washers
Flat
Washers
1-1/8"
Saddles 1-1/2" x 5/16" U-Bolts;
torque until bolts dent
tubing slightly
2-1/2"