DAVIS WeatherLink for Alarm Output Add. - Manual (Page 6)

6
You may select from the following settings:
Temperature:
Fahrenheit (°F) or 
Celsius (°C)
Note: Wind chill, dew point, degree-days, and temperature indexes are all displayed in the same unit of
measure as temperature.
Barometer:
Inches of Hg (in), Millimeters of Hg (mm), Millibars (mb), or 
HectoPascals (hPa) 
Wind Speed:
Miles per Hour (mph), Knots (knot), Kilometers per Hour (km/hr), or 
Meters per Second (m/s) 
Rain:
Inches (in) or Millimeters (mm) 
After selecting units of measure, select OK.
The Configuration Utility saves your choices. All information is displayed
in the units of measure you selected.
Output Test.
Pressing the Output Test button puts the Alarm Output data logger into
Output Test mode. In this mode, all other functions of the data logger
cease. Do not press this button unless you wish to perform a test because it
may disrupt the behavior of your connected electrical device.
This function is used to test the output of the Alarm Output data logger.
Push the button of the output you want to test. The button will be
depressed to indicate Closed circuit mode and raised to indicate Open
