DAVIS WeatherLink for Alarm Output Add. - Manual (Page 4)

4
can only enter this dialog box when no alarms are set. This prevents you
from hiding a parameter that is set as an alarm condition.)
Selecting Vantage Pro Plus automatically checks the Solar Radiation and
UV check boxes. You can also check them separately.
Note: If you have a Vantage Vue or Vantage Pro2 set to Vantage Pro. (The Alarm Output data logger
makes no distinction between Vantage Pro2, Vantage Pro or Vantage Vue.) If you have a

Vantage Pro2 Plus, set to Vantage Pro Plus.
The Leaf Wetness, Soil Moisture, Leaf Temperature, and Soil Temperature
selections refer to the sensors on the Leaf & Soil Moisture Temperature
Station or Soil Moisture/Temperature Station. Temp 1, Temp 2, Humidity
1, Humidity 2 refer to the sensors on the Wireless Temperature or Wireless
Temperature/Humidity Stations. Indicate the sensor by selecting the num-
ber that corresponds to the transmitter ID on your Wireless Temperature or
Temperature/Humidity Station.
The temperature and humidity readings are numbered according to their
station transmitter ID. So, for example, if you have an ISS on Transmitter
ID # 1 and a Temperature/Humidity Station on ID # 3, and a Temperature
Station on ID # 2, you would check the following dialog boxes in the
example shown below. There is no need to indicate your ISS Temperature