beautypg.com

Tools and materials needed, Installation steps – DAVIS EZ-Mount Installation User Manual

Page 3

background image

Tools and Materials Needed

Page 3

T

OOLS

AND

M

ATERIALS

N

EEDED

In addition to the components listed on page 2, you may need some of the fol-
lowing tools and materials.

Flat-Bladed Screwdriver

Phillips Screwdriver

Adjustable Wrench

Wire Cutter or Scissors

Wire Stripper or Knife (Industrial Installation Only)

Electrical Tape

Cable Clips or Weather-Resistant Cable Ties (with ability to be mounted)

Hammer

I

NSTALLATION

S

TEPS

This manual takes you through the step-by-step process of installing your
weather station. These steps are indicated below, along with their page num-
bers for easy reference:

Assemble and test the station, page 4

Detach the extension tube, page 4

Attach the anemometer, page 4

Attach the wind cups, page 4

Snip the cable tie in the rain collector, page 5

Apply power to the console, page 5

Attach the EZ-Sensor Arm, page 6

Connect sensor array to console, page 8

Check that the console and sensors are working properly, page 8

Re-attach rain collector cone and unplug sensor array

(or ICAM)

cable from console, page 8

Install the station, page 9

Choose locations for the sensor array and console, page 9

Mount, secure, and ground the sensor array, pages 10 & 11

Run sensor array cable

(or ICAM cable)

to console, page 11

Industrial stations only

: mount the ICAM, page 11

Mount the console, page 14

If, once installed, you encounter any problems with the station, please refer to
the troubleshooting guide on page 14 or call our technical support line (510-
732-7814) for assistance.