DAVIS EZ-Mount Installation - Manual (Page 10)

Page 10 EZ-Mount Advanced Station
Mounting the Sensor Array
The sensor array has been pre-assembled for easy installation. However, you
will still need to provide a solid mounting for the sensor array. Mounting hard-
ware has been included for the most common installations (see figures below).
If you are using the optional Mounting Tripod, consult the tripod’s manual for
mounting instructions.
CAUTION: The station’s wind direction is calibrated as if the horizontal part of the anemometer arm
were pointing west. If you plan to mount the station facing a different direction, see “Recali-
brating the Wind Vane” on page 12 for instructions on how to adjust the wind vane accord-
ingly.
Note: For roof mounting, we recommend the optional Mounting Tripod. If mounting on a roof, tower, or
other elevated structure without the Tripod, be sure to consider the effects of lightning, wind
loading and vibration and design the installation accordingly.
Support Tube
(swaged end)
Extension Tube
(21" long, no swaged end)
1-1/8" Saddle
5/16" Flat Washer
5/16" x 3" Lag Screw
12"
minimum
2' of
post
buried
Extension Tube
(see fence mounting for details)
4 x 4
treated
post,
8' long
Use post hole
digger, fill hole
with post hole
concrete
MOUNTING ON A FENCE MOUNTING ON A POST
Sensor Array
Sensor Array