DAVIS EZ-Mount Installation - Manual (Page 14)

Page 14 EZ-Mount Advanced Station
T ROUBLESHOOTING
While the EZ-Mount Advanced Station is designed to provide years of trouble-
free operation, occasional problems may arise. If you experience a problem,
please check the troubleshooting tips below before calling tech support.
✦ Console does not register any rainfall
Double check that you have cut the cable tie that secures the rain bucket
during shipping. See step 4 on page 5 for instructions. Also, make sure the
anemometer is not positioned above the rain collector cone.
✦ Console does not register wind direction correctly
Check that you have either pointed the anemometer arm westward when
mounting (page 10), or that you have recalibrated the wind vane to the
anemometer arm’s current direction.
✦ Console locks up
Insufficient power during power up or a power surge may cause the con-
sole to lock up. If this occurs, remove all power by disconnecting any bat-
tery backup and the
AC/DC power cord. Wait for 1 minute with all of the
power removed. Then re-connect the AC/DC power cord and listen for 2
beeps within 10 seconds.
Note: If you have the WeatherLink installed, listen for 3 beeps within 20 seconds and then, if all
is well, try communicating with the WeatherLink using the software.
Once you receive the final beep, install a fresh backup battery, if desired,
and put the console back into service.
✦ Display is flashing
Unit is operating under battery power. Check to be sure the power adapter
has not come unplugged from the console or outlet.
✦ Display is blank
Unit is not receiving power. Check to be sure the power adapter has not
come unplugged from the console or outlet.
If power is interrupted, battery may be installed incorrectly. Check and re-
install.
Battery may be run down or old. Replace.
✦ Display shows a series of dashes in place of function reading
Sensor for function which is "dashed out" is not plugged in.
Cable from sensor for function which is "dashed out" may have broken
wire. Check the areas where cables have been secured carefully.
A reading has exceeded the limits indicated on the specifications table.
For temperature, wind speed, or rainfall: calibration numbers may be
causing readings to exceed display limits. Check calibration number and
adjust if necessary.