beautypg.com

Mounting the console – DAVIS EZ-Mount Installation User Manual

Page 13

background image

Installing Your Station

Page 13

Mounting the Console

1. Plug the 8-conductor cable into the SENSOR INTERFACE jack on the console.
2. Apply power to the console (step 7 on page 8).
3. Install a backup battery in the console, if desired.

If you are using the optional EZ-Solar Power Kit, do not install a backup
battery

.

4. Mount the console on a desk, shelf or wall.

You can change the console’s orientation by reversing the mounting base, as
shown below.

D

ISPLAYING

THE

C

ONSOLE

ON

A

D

ESK

OR

T

ABLE

D

ISPLAYING

THE

C

ONSOLE

ON

A

S

HELF

Or, to display the console on a wall, follow these steps:

a. Hold the mounting base flat against the wall and use a pencil to mark

the location of the two keyholes.

b. Use an electric drill with a #36 or 2.5-mm drill bit to make pilot holes in

these locations.

c. Using a screwdriver, drive the two pan head

screws into the wall. Leave at least 1/8 inch (3 mm)
between the wall and the heads of the screw.

d. Depending on how high you mount the console on

the wall, you can use either tabletop or shelf orien-
tation. Attach the mounting base in the orientation
you prefer.

e. Slide the keyholes on the back of the mounting

base over the two screw heads. Lock the console
into place by gently sliding it downward.