DAVIS Envoy8X Long Range Repeater Installation Addendum - Manual (Page 3)

1
Welcome!
The Long Range Repeater can be used with any wireless Vantage Pro2
™
or Vantage Vue
transmitting station to re-transmit to a Vantage Pro2 compatible receiver (Vantage Pro2 or
Vantage Vue console; Weather Envoy or Envoy8X, or another Vantage Pro2 wireless
receiver or repeater). The Long Range Repeater works in much the same way as the Van-
tage Pro2 wireless repeater, but extends the distance between a repeater and a receiver by
up to 10 times that of the Vantage Pro2 wireless repeater (#7626/ 7627).
Long Repeater Addendum Overview
This addendum provides additions information specific to the installation and use of the
Long Range Repeaters and is intended to be used in conjunction with the Wireless
Repeater Installation Manual. The table below shows the location of the information
required to install and maintain your Long Range Repeaters:
Section/Procedure
This
Addendum
Wireless
Repeater
Manual
Components and Hardware X
Repeater Board Contents X X
Additional Antenna Components and Hardware X
Tools for Setup X
Additional Tools for Setup X
Wireless Repeater Introduction X
Repeater Configurations/Architecture X
Long Range Repeater Antenna Configuration X
Applying Power X
Single Repeater Installation X
Advanced Repeater Installation X
Mounting Long Range Wireless Repeater and Antennas X
Connecting External Antennas to the Repeater X
Console and WeatherLink Configuration X
Repeater Communication Troubleshooting X
Long Range Repeater Specification X