DAVIS Envoy8X Long Range Repeater Installation Addendum - Manual (Page 11)

9
Mounting the Repeater and External Antennas
The antenna configuration and wireless repeater can be mounted on a pole at a designated
location. Use the provided U-bolts for the wireless repeater and the U-bolts provided for
each antenna type to install them all to a pole.
Note: To accommodate your antenna configuration (omni and Yagi or Yagi and Yagi), mount the antennas
first before mounting the wireless repeater enclosure.
Omni and Yagi Antenna Combination Assembly
The omni and Yagi combination assembly should be performed from the bottom antenna
(Yagi) up to the top antenna (Omni) so that the omni antenna can be installed flush to the
top of the pole.
1. Place the Yagi on the pole in the general vicinity of the desired station/repeater/
receiver.
2. Place a U-bolt around the pole and through the two holes at the top and of the antenna
plate.
3. Place a flat washer, a lock washer and a hex nut on each of the bolt ends.
Omni Antenna
Yagi Antenna
5/16"
U-Bolts
Flat Washer
Lock Washer
Nut
48"
Antenna
Cables
2" Diam.
Pole