Alliance Laundry Systems HX - Manual (Page 77)

9001900 75
Section 4 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electrical power to the washer-extractor before servicing it.
• Close the gas shut-off valve to the washer-extractor (when applicable) before servicing it.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W461R1
WARNING
30. MOTOR REMOVAL AND REPLACEMENT
(18, 25, 35, 55 and 75-Pound Capacity Models)
REMOVAL
Refer to Figure 15.
a. Turn power off to the machine.
b. Remove the rear panel. Refer to Paragraph 24.
c. Remove the drive belt. Refer to Paragraph 26.
d. Loosen the motor pulley’s setscrew and remove
the motor pulley from the motor.
e. Remove the motor belt tensioner bolts from the
motor plate.
f. Remove the motor mounting bolts from the
motor plate.
g. Disconnect the motor wiring.
h. Remove the motor from the machine.
REPLACEMENT
a. Connect the motor wiring.
b. Reinstall the motor onto the motor plate.
c. Reinstall the motor pulley to the motor and
check the pulley’s alignment.
d. Reinstall the motor belt tensioner bolts.
e. Reinstall the belt.
f. Re-tension the belt. Refer to Paragraph 26.
g. Replace the rear panel. Refer to Paragraph 24.
Figure 15
CFD13S
Motor
Pulley
Motor
Motor
Plate