Excessive cycle time – Alliance Laundry Systems HX User Manual

Page 65

9001900

Section 3 Troubleshooting

17. EXCESSIVE CYCLE TIME

When experiencing excessive cycle time, there are three main causes which are as follows:

a. Fill Time:

(1) Check for excessively long fill times. Refer to the “Fill Alarm Analysis” flowchart if any are found.
(2) Check for excessively long programmed fill times.

NOTE: All pre-programmed fill times are for 5 minutes. Any fill should easily complete during this time.

b. Drain Time:

(1) Look for excessively long programmed drain times (i.e., greater than one minute).

NOTE: Any drain step should not exceed 30-40 seconds.

c. Unnecessary Programming Steps:

(1) E.g., in the first fill of a cycle, if “S02 CXX 0:00:45” “SUPPLY1” is programmed for 45 seconds and

“S03 CXX 0:00:45” “SUPPLY2” is programmed for 45 seconds, the two steps can be accomplished
together at the same time, saving 45 seconds. Refer to the “Programming Multiple Supply Steps” section
of your washer-extractor’s programming manual.

This manual is related to the following products:

UX OPL SX