JKS OGS126 User Manual
Installation instructions, Welcome, Important
JKSOGS125 - JKSOGS126
JKS Adjustable Trackbar Installation
Page 1
INSTALLATION
INSTRUCTIONS
Product: Adjustable Trackbar
Part Number: JKSOGS125 - JKSOGS126
Welcome
CONGRATULATIONS on purchasing a new Adjust-
able Trackbar from JKS Manufacturing. We are com-
mitted to providing you with the best products avail-
able and your satisfaction is our first priority.
PLEASE READ these Installation Instructions careful-
ly, and save them for future reference, as they contain
important installation and maintenance information.
Important
NOT COMPATIBLE WITH right hand drive
vehicles.
CHECK TORQUE SPECIFICATIONS regularly.
Tools Required
Metric/Standard Socket Wrench Set
Torque Wrench
Tie Rod End Remover *
Tape Measure
1-1/2” Open-End Wrench
9/16” Drill Bit
Flat Metal File *
Heavy Duty Ratchet Strap *
Anti-Seize Lubricant
Grease Gun with Zerk Fitting Coupler
Wheel Bearing Grease
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
Parts
A
OE Rubber Bushing
B
Male Threaded (Axle) End
C
1” NF Jam Nut
D
Female Threaded (Chassis) End
E
9/16” SAE Flat Washer
F
Preload Washer
G
9/16” NF GR8 Ovalok Nut
H
Polyurethane Bushing
I
Snap Ring
J
9/16” x 4-1/2” GR8 Greaseable Bolt
K
Preload Washer
L
2.5” Johnny Joint Ball
M
Polyurethane Bushing
N
Tapered Split Cone
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036