JKS 9601 User Manual

Page 2

JKS9601

JKS Shock Conversion Installation

2 Page

Slide top end of shock absorber into Shock Con-

version (A) until mounting holes align.

Insert 1/2” x 2-1/4” Bolt (C) and thread into welded

nut.

Secure Shock Conversion (A) in a vice and

tighten the 1/2” Bolt (C) to 60 ft-lbs. using a torque

wrench.

While still secured in the vice, completely thread

the M20 Nylock Nut (B) onto threaded stud and

remove.

HINT: This cuts a groove in the Nylock

material, making final installation easier.

3. RE-INSTALL SHOCK ABSORBERS

Insert threaded stud of Shock Conversion (A)

through original shock mounting hole in upper

fender well of vehicle.

IMPORTANT: Shock Conversion must be positioned

with the JKS decal facing you (away from vehicle).

Install the M20 Nylock Nut (B) onto threaded stud

of Shock Conversion (A) from above the shock

mounting bracket.

HINT: Shock may be used as

a lever to hold Shock Conversion in position while

installing Nylock Nut.

Tighten the M20 Nylock Nut (B) to 80 ft-lbs.

Install shock absorber to lower mount per factory

service manual instructions.

Revision Date 10/30/2013