JKS OGS920 User Manual
Page 2
JKSOGS920
FAB Track Bar Relocation Bracket
2 Page
2. WeLd TRACk bAR bRACkeT TO AxLe
Place the bracket on the housing as shown. The
rear bracket edge should seat against the factory
track bar mount. Align the bracket face with the
OE track bar mount. The new bracket edge should
line up with the axle tube.
Remove the bracket and clean the surfaces to be
welded.
Tack weld the bracket to the axle and then fully
weld the bracket along the axle tube and OE track
bar bracket.
Allow the parts to cool and paint to prevent rust.
©2013 JKS Manufacturing, Inc & Aftermarketing, LLC
Revision Date 12/13/2013
See also other documents in the category JKS For the car:
- 8100 (3 pages)
- 9901 (4 pages)
- 9902 (4 pages)
- 9903 (4 pages)
- 9904 (5 pages)
- OGS115 (2 pages)
- OGS161 (4 pages)
- OGS168 (3 pages)
- OGS169 (2 pages)
- OGS999 (3 pages)
- 2944 (2 pages)
- 9601 (2 pages)
- 9602 (2 pages)
- 9603 (2 pages)
- 9604 (2 pages)
- 9605 (2 pages)
- 9607 (2 pages)
- 9608 (2 pages)
- PN2291 (2 pages)
- PN2292 (2 pages)
- OGS166 (9 pages)
- OGS924 (2 pages)
- OGS960 (6 pages)
- TR100 (1 page)
- TR300 (1 page)
- PN TR301 (1 page)
- 1100 (4 pages)
- 1600 (1 page)
- 2200 (4 pages)
- 2210 (5 pages)
- 2400 (2 pages)
- 2550 (3 pages)
- 2570 (4 pages)
- 2700 (8 pages)
- 2710 (5 pages)
- 6100 (3 pages)
- 6125 (3 pages)
- 6155 (2 pages)
- 7100 (2 pages)
- 7101 (2 pages)
- 7150 (3 pages)
- BSE201 (5 pages)
- BSE251 (6 pages)
- OGS651 (1 page)