JKS 9903 User Manual

Page 3

JKS 9903

JKS Body Lift Installation

Page 3

4. INSERT BODY PUCKS

Position a hydraulic jack next to body mount

DRIVER SIDE of vehicle.

Place a sturdy wooden block between the hydrau-

lic jack pad and channel portion of vehicle body for

protection.

Carefully raise the vehicle body just enough to

insert the 1.25” Body Pucks (A) between body and
factory body mounts

2 3 4 5

and

NOTE: Position Body Pucks with recessed bottom

encapsulating the OE body mount.

Locate the factory rubber radiator bumper be-

neath the grill panel and replace with the supplied

Extended Radiator Bumper (F) using the original

hardware.

With Body Pucks (A) and Extended Radiator

Bumper (F) inserted, slowly lower the vehicle body

onto mounts, ensuring correct alignment of body

on chassis.

Apply medium strength thread locking compound

to three of the supplied 1/2” x 4-1/2” Bolts (B) and

two of the 7/16” x 4” Bolts (D).

Insert the 1/2” x 4-1/2” Bolts (B) with 1/2” Flat
Washers (C) into body mount positions

2 3

and

. Insert the 7/16” x 4” Bolts (D) with 7/16” Flat

Washers (E) into body mount positions

and

Start threads but DO NOT TIGHTEN bolts until

instructed.