Avaya AP-6 - Manual (Page 470)

Wireless Interface SSID/VLAN/Security Commands
A-124 Avaya Wireless AP-4/5/6 User’s Guide
To configure an SSID and VLAN pair, and the security mode associated
with the pair, use the following command:
Depending on the configured security mode, the following parameters
must be configured:
NOTE:
If you have two or more SSIDs per interface with a security mode of
None, be aware that security being applied in the VLAN is not being
applied in the wireless network.
Syntax:
[Device-Name]> set wifssidtbl
Example:
[Device-Name]> set wifssidtbl 3 2 Engineering
1050 enable WPA
Security
Mode
Key 0 Key 1 Key 2 Key 3 Tx Key
Key
Length Rekeying
Interval PSK
Value PSK Pass
Phrase
None Inactive Inactive Inactive Inactive Inactive Inactive Inactive Inactive Inactive
802.1x Inactive Inactive Inactive Inactive Inactive Active Active Inactive Inactive
Mixed Inactive Active Inactive Inactive Inactive Active Active Inactive Inactive
WPA Inactive Inactive Inactive Inactive Inactive Inactive Inactive Inactive Inactive
WPA-PSK Inactive Inactive Inactive Inactive Inactive Inactive Inactive Active Active
WEP Active Inactive Inactive Inactive Inactive Inactive Inactive Inactive Inactive