Avaya AP-6 - Manual (Page 453)

802.11b Wireless Interface Commands
Avaya Wireless AP-4/5/6 User’s Guide A-107
Perform the following commands to enable TX Power Control and set the
transmit power level:
[Device-Name]> set txpowercontrol enable
[Device-Name]> set wif currenttxpowerlevel
Allowed values are: 1 (100%), 2 (50%), 3 (25%), 4 (12.5%)
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]> set wif autochannel
[Device-Name]> reboot 0
Enable/Disable Closed System
[Device-Name]> set wif closedsys
802.11b Wireless Interface Commands
The wireless interface group parameter is wif. For Single-radio APs, the
wireless interface uses table index 3.
See Interfaces for information on these parameters.
Jack--Why are mode and tx power control not in the tables?