Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 8)

About the Scan Tool
BATTERY REPLACEMENT
6 OBD2
On some Asian and European vehicles the DLC is located
behind the “ashtray” (the ashtray must be removed to
access it) or on the far left corner of the dash. If the DLC
cannot be located, consult the vehicle’s service manual for
the location.
BATTERY REPLACEMENT
Replace batteries when the battery symbol is visible on display
and/or the 3 LEDS are all lit and no other data is visible on screen.
1.
Locate the battery cover on the back of the Scan Tool.
2.
Slide the battery cover off (use your fingers).
3.
Replace batteries with three AA-size batteries (for longer life, use
Alkaline-type batteries).
4.
Reinstall the battery cover on the back of the Scan Tool.
Language Selection After Battery Installation
The first time the Scan Tool is turned on, you must select the desired
display language (English, French or Spanish). Select the display
language as follows:
1.
Press and hold the POWER/LINK
button for approximately 3 seconds to
turn the Scan Tool “ON.”
„ The Select Language screen dis-
plays.
2.
Use the UP
and DOWN buttons,
as necessary, to highlight the desired
display language.
3.
When the desired display language is selected, press the
ENTER/LD button to confirm your selection.
„ The display shows the "To Link" message in the selected display
language. Press the POWER/LINK
button to turn the Scan
Tool "off."
„ After the initial language selection is performed, it as well as
other settings can be changed as desired. See ADJUSTMENTS
AND SETTINGS on page 7 for further instructions.