Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 59)

Additional Tests
NON-CONTINUOUS TEST
OBD2 57
NON-CONTINUOUS TEST
The Non-Continuous Test function retrieves and displays test results
for emission-related powertrain components and systems that are not
continuously monitored. The tests available are determined by the
vehicle manufacturer.
The Scan Tool does not perform non-continuous test, but
retrieves results from the most recently performed tests from
the on-board computer’s memory. You may retrieve non-
continuous test results for only one test at any given time.
1.
From the "Mode Selection Menu", use
the UP and DOWN buttons, as
necessary, to highlight Non-
Continuous Test, then press the
ENTER/LD
button.
„ The “Select Test” screen displays.
The screen shows all tests
applicable to the vehicle under test.
Refer to the vehicle’s service repair
manual for information related to
non-continuous tests.
If non-continuous tests are not
supported by the vehicle under test,
an advisory message shows on the
Scan Tool's display. Press the
ENTER/LD
button to return to
the Mode Selection menu.
2.
Use the UP
and DOWN buttons,
as necessary, to highlight the desired
test, then press the ENTER/LD
button.
3.
A “One moment please. . .” message
diplays while the request is sent to the
vehicle’s on-board computer.
4.
When test results have been retrieved, data for the selected test will
show on the Scan Tool’s display. The display shows the following
information:
„ Test ID number
„ Module ID number
„ Component ID number
„ Min or Max test limit
Only one test limit, either Min
or Max, is shown for any given
test.
„ Test Value and status