Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 10)

About the Scan Tool
ADJUSTMENTS AND SETTINGS
8 OBD2
3.
Press the DOWN
button to increase the brightness of the display
(make the display lighter).
4.
When the desired brightness is obtained, press the ENTER/LD
button to save your changes and return to the MENU.
Searching for a DTC Definition Using the DTC Library
1.
Use the UP
and DOWN buttons,
as necessary, to highlight DTC Library
in the MENU, then press the ENTER/LD
button.
„ The Enter DTC screen displays. The
screen shows the code “P0001”,
with the “P” flashing.
2.
Use the UP
and DOWN buttons,
as necessary, to scroll to the desired
DTC type (P=Powertrain, U=Network,
B=Body, C=Chassis), then press the
DTC SCROLL
button.
„ The selected character displays “solid”,
and the next character begins flashing.
3.
Select the remaining characters in the DTC in the same way,
pressing the DTC SCROLL button to confirm each character.
When you have selected all the DTC characters, press the
ENTER/LD
button to view the DTC definition.
„ If you entered a “Generic” DTC
(DTCs that start with “P0”, “P2” and
some “P3”):
- The selected DTC and DTC
definition (if available) show on
the Scan Tool’s display.
If a definition for the DTC you
entered is not available, the “To
Link” screen displays.
„ If you entered a “Manufacturer-Specific” DTC (DTCs that start
with “P1” and some “P3”):
- The “Select Manufacturer” screen
displays.
- Use the UP and DOWN
buttons, as necessary, to high-
light the appropriate manufacturer,
then press the ENTER/LD
button to display the correct DTC
for your vehicle.