Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 12)

About the Scan Tool
ADJUSTMENTS AND SETTINGS
10 OBD2
Setting the Unit of Measurement
1.
Use the UP
and DOWN buttons,
as necessary, to highlight Unit of
Measurement in the MENU, then press
the ENTER/LD
button.
2.
Press the UP
or DOWN button,
as necessary, to highlight the desired
Unit of Measurement.
3.
When the desired Unit of Measurement
value is selected, press the ENTER/LD
button to save your changes.
Exiting the MENU Mode
1.
Use the UP
and DOWN buttons, as necessary, to highlight
Menu Exit in the MENU, then press the ENTER/LD button.
„ The display returns to the DTC screen (if data is currently stored
in the Scan Tool) or to the "To Link" message (if no data is
currently stored in the Scan Tool).