Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 54)

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
52 OBD2
2.
Use the UP
and DOWN buttons,
as necessary, to highlight “Live Data
Menu”, then press the ENTER/LD
button.
„ The "Live Data Menu" displays.
3.
Use the UP
and DOWN buttons,
as necessary, to highlight “Record Live
Data”, then press the ENTER/LD
button.
„ The "Record Live Data Menu" dis-
plays.
4.
Use the UP
and DOWN buttons,
as necessary, to highlight “Record by
manual trigger”, then press the
ENTER/LD
button.
5.
When the "Record by Manual Trigger" screen displays, select the
desired trigger point as follows:
The Scan Tool is capable of recording approximately 20
frames of Live Data. Record by DTC trigger lets you select the
point in time at which you wish the Scan Tool to begin
recording Live Data. You can set the trigger point to record the
20 frames of data before an event (when the DTC was set),
after the event, or in the middle (10 frames before and 10
frames after the event.
„ Beginning - records approximately
20 frames of Live Data after the
ENTER/LD
button was pressed.
„ Middle - records approximately 10
frames of Live Data before and 10
frames after the ENTER/LD
button was pressed.
„ End - records approximately 20 frames of Live Data before the
ENTER/LD
button was pressed.
6.
Use the UP
and DOWN buttons, as necessary, to select the
desired trigger point, then press the ENTER/LD button.
„ A "One moment please. . ."
message shows on the display.
When the Scan Tool is ready to
record Live Data, the "Record Live
Data" screen displays.
7.
Put the engine in the operating condition
where the problem manifests itself.