Equus 3160 - ABS/SRS + OBD2 Scan Tool - Manual (Page 32)

Using the Code Reader
VIEWING ABS DTCs
30 OBD2
Reading ABS DTCs
1.
Use the UP
and DOWN buttons, as necessary, to highlight
Read ABS DTCs, then press the ENTER/LD button.
„ A "One moment please" message
displays while the Scan Tool
retrieves the selected DTCs.
„ If the Scan Tool fails to link to the
vehicle’s computer, a "Linking
Failed" message shows on the Scan
Tool’s display.
- Verify the ignition is ON, then
press the ENTER/LD button to continue.
„ If the vehicle does not support ABS communication, an advisory
message shows on the Scan Tool’s display. Press the
ENTER/LD
button to return to exit.
2.
To read the display:
Refer to DISPLAY FUNCTIONS on page 12 for a description
of LCD display elements.
„ A visible icon indicates that the Scan Tool is being powered
through the vehicle’s DLC connector.
„ A visible icon indicates that the Scan Tool is linked to
(communicating with) the vehicle’s computer.
„ The upper right hand corner of the
display shows the number of the
code currently being displayed, the
total number of codes retrieved.
„ The Diagnostic Trouble Code (DTC)
and related code definition are
shown in the lower section of the
LCD display.
I/M MONITOR STATUS icons are not displayed when viewing
ABS DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information. Use the UP
and DOWN buttons, as necessary, to view the additional
information.
„ The Scan Tool will display a code
only if codes are present in the
vehicle’s computer memory. If no
codes are present, a "No ABS
DTC’s are presently stored in the
vehicle’s computer" is displayed.
Press the ENTER/LD
button to
return to the ABS Menu.