Boonton 9240 RF Voltmeter - Manual (Page 98)

Boonton 9240 Series RF Power Meter
NO. MESSAGE DESCRIPTION
-245 "Sensor
Disconnected."
-246 “Sensor voltage error”
-248 "Keyboard
error"
-249 "FPGA download err"
-263 “MFS Init”
-264 “Flash
init”
-266 “Mem
restore”
-280 “Program
error”
-295
"Command not in language."
-296 "Data out of range, set to limit."
-297 "Command not supported."
-313 “Cal
mem lost”
-340 “Calibration
failed”
-350 "Error queue overflow"
-360 “Communication Error”
-362 “Snsr2 Page Blank”
-363
“Snsr1 Page Blank”
-
364 “Sensor access fault”
-371
"Err CH2 Data Adapter Data" Checksum failure of the Channel 2 Data Adapter EEPROM.
-372
"Err CH1 Data Adapter Data" Checksum failure of the Channel 1 Data Adapter EEPROM .
-373 “Measurement Error”
-375 "Cmd not accepted"
-376
"I2C Timeout" Software has timed-out while communicating over the I2C bus.
-377
"No I2C Ack" Missing Acknowledge signal while assessing the I2C bus.
-397 "Err CW signal."
Appendix A
7-2