Boonton 9240 RF Voltmeter - Manual (Page 81)

Boonton 9240 Series RF Voltmeter
5.5.13 SYSTem Subsystem
The SYSTem group of commands is used to control system-level functions not directly related to instrument measurement
performance. SYSTem commands are used to return error codes or messages from the voltmeter error queue, control
hardware features and configure communication parameters for the GPIB.
SYSTem:BEEP[:ENABle]
Description: Set or return the status of the audible keyboard beeper.
Syntax: SYSTem:BEEP[:ENABle]
Argument: = { 0, 1, OFF, ON }
SYSTem:BEEP:IMMediate
Description: Causes the system to emit an audible beep. Command only; does not respond to a query.
Syntax: SYSTem:BEEP:IMMediate
Argument: None
SYSTem:COMMunicate:GPIB:ADDRess
Description: Set or return the GPIB bus address.
Syntax: SYSTem:COMMunicate:GPIB:ADDRess
Argument: = 1 to 30
SYSTem:COMMunicate:GPIB:EOI
Description: Set or return the status of the GPIB EOI .
Syntax: SYSTem:COMMunicate:GPIB:EOI
Argument: = { 0, 1, OFF, ON }
SYSTem:COMMunicate:GPIB:LISTen
Description: Set or return the GPIB Listen end-of-string terminator .
Syntax: SYSTem:COMMunicate:GPIB:LISTen
Argument: = {LF, CR, CRLF, EOIONLY}
Remote Operation
5-31