BMR Suspension TAS005 User Manual
Page 7
7
(CONTINUED)
31. At this point it is necessary to assemble the coil-over shocks. Using Image 16 as a guide,
thread the lower adjuster onto the shock body and continue threading until it is all the
way to the bottom. Place a spring over the
shock and then insert the upper spring
mount on top of the spring and over the
shock shaft. Insert the spring clip. Thread
the lower shock adjuster up until the
spring has no more slack and seats
squarely on the upper and lower mounts.
32. Position the rear end housing in the wheel
wells.
33. Install the Upper Torque Arm braces onto
the BMR 9” axle housing as shown in Image 17 below. This requires two ½ x 3.75”
bolts, nuts and stainless washers. Place the washer under the nut side and leave the nuts
finger tight.
34. Position the front of the torque arm into the mount on the BMR transmission cross-
member and insert the provided ½” x 4” bolt. Thread a stainless washer and nut onto the
exposed threads and tighten to 80 ft/lbs. (Image 18)
34.
35.
36.
37.