BMR Suspension DSL002 User Manual
BMR Suspension For the car
B-BODY DRIVESHAFT LOOP INSTALLATION
Part # DSL002
Tools Required:
Jack
Jack
Stands
13mm
wrench
15mm
wrench
6mm Allen wrench
10mm wrench
Installation:
1. Lift vehicle and support with jack stands under the frame rails.
2. Remove the driveshaft and tape the cups onto the u-joint to avoid needle-bearing loss.
3. Using the 13mm wrench, remove the OE chassis brace that is located just behind the
transmission tail shaft.
4. Using the 15mm wrench, remove the bolts from the drivers’ side exhaust flange and
temporarily lower the exhaust.
5. Place the driveshaft loop into position where the OE brace was bolted with the loop facing
upwards. Insert bolts and tighten.
6. Reinstall the driver’s side exhaust pipe and tighten bolts. Reinstall the driveshaft and tighten
bolts. Lower car.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, Buyer
assumes all risk of any damage caused to the vehicle or person during installation or use of this product.