BMR Suspension DSL014 - Manual

DRIVESHAFT SAFETY LOOP INSTALLATION
DSL014– 2010 Camaro M6
RECOMMENDED TOOLS:
(2) 9/16” wrenches
15mm socket
3/8” drive ratchet or impact
Hydraulic jack and jack stands or Hydraulic service lift
Drill with 3/8” drill-bit
INSTALLATION:
1. Lift vehicle and support safely under frame rails.
2. Support the transmission using a jack stand or jack.
3. Using a 15mm socket, remove the (2) transmission mount nuts.
4. Using the same socket, remove the (4) transmission cross-
member bolts then remove the cross-member.
1
5. Position the main BMR mounting bracket onto the factory cross-
member as shown in Image 1. Make sure that the BMR bracket sits flush on
the transmission mount surface and make sure the holes in the BMR bracket
line up with the holes on the OE cross-member. Once positioned correctly, it
may be easier to
proceed if the
bracket is
clamped to the
cross-member.
6. Turn the cross-
member/bracket
assembly upside
down and mark
the cross-
member for
drilling using
the mounting
holes as a guide.
See Image 2.
7. Remove the BMR mounting bracket and drill the two holes into the factory
cross-member as shown in Image 3.
8. Using the supplied 3/8” x 1” bolts, washers and nuts, bolt the BMR
mounting bracket to the OE crossmember as shown in Image 4.