BMR Suspension TAS005 User Manual
Page 3
3
(CONTINUED)
9. Support the rear end with jack stands.
10. Using a 3/4” socket, remove the leaf spring U-bolts on the rear end. (Image 2)
NOTE: the image shown has aftermarket traction bars installed. Leaf spring mounts
may appear slightly different in nature.
11. Using a 5/8” socket, loosen and remove the rear leaf spring shackle bolts. Loosen the
upper shackle bolt at the frame and remove the shackles. (Image 3)
12. Using a 9/16” socket, remove the (3) bolts on the front spring mount of each leaf spring.
(Image 4) NOTE: the image shown had aftermarket traction bars installed. Front leaf
spring eye may appear slightly different in nature.
13. Once all bolts are removed, remove the leaf springs.
14. Remove the rear end and set aside.
15. Loosen the bolts and remove the front spring pockets. (Image 5)
16. Install the BMR trailing arms into the leaf spring pockets as shown using the provided ½”
x 5” bolts. Thread a stainless washer under the nut then tighten to 80 ft/lbs. (Image 6)
17. Re-install the spring pockets with control arms into the body and leave bolts finger tight.