BMR Suspension ELK011 - Manual

ELK011
INSTALLATION INSTRUCTIONS
2012-2014 Camaro
Tools required:
Jack and jack stands
Wrenches: 8mm, 14mm, 18mm, 19mm
Grease gun
Installation:
1. Lift front of vehicle and remove both
wheels/tires.
2. Use an 18mm wrench to remove the
nuts from the OE sway bar end links.
If the entire shaft of the end link
spins, use an 8mm wrench to hold the
shaft from the end while loosening
the nut.
3. Remove the OE end link.
4. Using the OE end link as a guide,
adjust the BMR end link to the same
length. Once adjusted, tighten the jam
nuts on the BMR end link using a
19mm wrench.
5. Install the BMR end link onto the
vehicle. Tighten the nuts using a
19mm wrench. If the entire shaft
spins while tightening, use a 14mm
wrench to hold the base of the shaft
while tightening the nut.
6. Duplicate steps 2-5 on the other side
then re-install the wheels/tires and
lower the vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As
such, Buyer assumes all risk of any injury caused to the vehicle/person during installation or use of this product.