BMR Suspension BK016 User Manual
BMR Suspension For the car
Rear Subframe Bushing Inserts
BK016
Required Tools:
Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar
Installation:
1. Lift vehicle and support with stands under the rocker jack points as shown in
Image 1 below.
2. Remove both rear wheels.
3. Using a 15mm socket, remove the driveshaft tunnel brace. See Image 2.
4. Using a 15mm socket, loosen the exhaust
clamps at the front of the exhaust.
5. Using a helper, slide the rear muffler
mounts off the mounting dowels (Image 3)
and then pull the entire exhaust assembly
rearward and out of the car.
Continued
See also other documents in the category BMR Suspension For the car:
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)