BMR Suspension SB035 - Manual

SB035 INSTALLATION INSTRUCTIONS
TOOLS REQUIRED:
Wrenches – 9/16”, 11/16”, 8mm, 19mm
Sockets – 9/16”
3/8” drive ratchet
Electric drill with 3/8” drill bit
INSTALLATION:
1. Lift rear of vehicle and support with jack stands under the frame rails.
2. Remove factory rear sway bar, if equipped.
3. Position the two supplied U-bolts over the axle as shown in IMAGE 1.
4. Lube the inside of the polyurethane bushings with the supplied grease then position the bushings
over the sway bar on the outside of the thrust washers as shown in IMAGE 2.
5. Place the bushing saddles over the bushings as shown in IMAGE 2.
6. Using a helper or a stand to hold one side, lift the sway bar up into position. Place one of the
supplied axle brackets over the U-bolt on the axle and then connect the sway bar bushing saddle
to the U-bolt, “sandwiching” the axle bracket between the bushing and the axle.
7. Repeat for the other side. The mount should look like IMAGE 3 when connected properly.
8. Measure side-to-side to make sure the
sway bar is properly centered. Also,
viewing from directly underneath the
axle, verify that the sway bar is on the
centerline of the axle and the brackets
are not crooked.
9. Once the sway bar is properly
positioned, tighten all (4) nuts on the U-
bolts using a 9/16” socket.
1