BMR Suspension BK018 User Manual
BMR Suspension For the car
FRONT LOWER CONTROL ARM BUSHINGS (BK018)
Required Tools:
• Hydraulic jack and 2 stands (lift optional but recommended)
• Wrenches – 18mm
• Sockets – 18mm, 21mm
• Pry-bar
• Brass hammer
Installation:
1. Lift vehicle and support with
stands under the rocker jack points
or K-member.
2. Remove both front wheels/tires.
3. Using an 18mm socket and
wrench, remove the inner
mounting bolt on the lower control
arm. See Image 1 to the right.
4. Using a 21mm socket, remove the outer ball
joint nut. See Image 2 to the right.
5. Knock the ball joint loose from the spindle
using a brass hammer.
6. Remove the control arm.
Continued
1
See also other documents in the category BMR Suspension For the car:
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)