BMR Suspension BK027 User Manual
BMR Suspension For the car
Delrin
Rear Subframe Bushings
BK027
Required Tools:
Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar
Rubber Mallet
Sawzall
Installation:
1. Lift vehicle and support with stands under the
rocker jack points as shown in Image 1
below.
2. Remove both rear wheels.
3. Using a 15mm socket, remove the driveshaft
tunnel brace. See Image 2.
4. Using a 15mm socket, loosen the exhaust
clamps at the front of the exhaust.
5. Using a helper, slide the rear muffler mounts
off the mounting dowels (Image 3) and then
pull the entire exhaust assembly rearward and
out of the car.
Continued
See also other documents in the category BMR Suspension For the car:
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)