American Fibertek SM9p - Manual (Page 41)

33
Port Mirroring Commands Set
Netstar Commands Level Description Example
monitor rx
[Port ID]
G Set RX destination
port of monitor function
switch(config)#monitor rx
monitor tx
[Port ID]
G Set TX destination port
of monitor function
switch(config)#monitor tx
show monitor P Show port monitor
information
switch#show monitor
monitor
[RX|TX|Both]
I Configure source port
of monitor function
switch(config)#interface
fastEthernet 2
switch(config-if)#monitor RX
show monitor I Show port monitor
information
switch(config)#interface
fastEthernet 2
switch(config-if)#show monitor
no monitor I Disable source port of
monitor function
switch(config)#interface
fastEthernet 2
switch(config-if)#no monitor
802.1x Commands Set
Netstar Commands Level Description Example
8021x enable G Use the 802.1x global
configuration
command to enable
802.1x protocols.
switch(config)# 8021x enable
8021x system radiusip
[IP address]
G Use the 802.1x system
radius IP global
configuration
command to change
the radius server IP.
switch(config)# 8021x system
radiusip 192.168.1.1