American Fibertek SM9p - Manual (Page 141)

133
ID" and click Select .
3. LACP: If enable, the group is LACP static trunk group. If disable, the group is local
static trunk group. All ports support LACP dynamic trunk group. If connecting to the
device that also supports LACP, the LACP dynamic trunk group will be created
automatically.
4. Work ports: allow max four ports can be aggregated at the same time. If LACP static
trunk group, the exceed ports are standby and able to aggregate if work ports fail. If it
is local static trunk group, the number must be as same as the group member ports.
5. Select the ports to join the trunk group. Allow max four ports can be aggregated at the
same time. Click Add button to add the port. To remove unwanted ports, select
the port and click Remove button.
6. If LACP enable, you can configure LACP Active/Passive status in each ports on State
Activity page.
7. Click Apply .
8. Use Delete button to delete Trunk Group. Select the Group ID and click Delete
button.