Trunk commands set – American Fibertek SM9p User Manual
Page 29
21
limit.
show bandwidth
I
Show interfaces
bandwidth control
switch(config)#interface
fastEthernet 2
switch(config-if)#show bandwidth
state
[Enable | Disable]
I
Use the state interface
configuration
command to specify
the state mode of
operation for Ethernet
ports. Use the disable
form of this command
to disable the port.
switch(config)#interface
fastEthernet 2
(config-if)#state Disable
show interface
configuration
I
show interface
configuration status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
configuration
show interface status
I
show interface actual
status
switch(config)#interface
fastEthernet 2
(config-if)#show interface status
show interface
accounting
I
show interface statistic
counter
switch(config)#interface
fastEthernet 2
(config-if)#show interface
accounting
no accounting
I
Clear interface
accounting information
switch(config)#interface
fastEthernet 2
switch(config-if)#no accounting
Trunk Commands Set
Netstar Commands
Level Description
Example
aggregator priority
G
Set port group system switch(config)#aggregator priority