American Fibertek SM9p - Manual (Page 24)

16
CLI Management
The system supports two types of console management – CLI command and Menu
selection. After you login to the system, you will see a command prompt. To enter CLI
management interface, enter “enable” command. The following table lists the CLI
commands and description.
System Commands Set
Netstar Commands Level Description Example
show config E Show switch
configuration
Switch>show config
show terminal P Show console
information
Switch#show terminal
write memory P Save user
configuration into
permanent memory
(flash rom)
Switch#write memory
system name
[System Name]
G Configure system
name
Switch(config)#system name xxx
system location
[System Location]
G Set switch system
location string
switch(config)#system location
xxx
system description
[System Description]
G Set switch system
description string
switch(config)#system
description xxx
system contact
[System Contact]
G Set switch system
contact window string
switch(config)#system contact
xxx
show system-info E Show system
information
Switch>show system-info
ip address
[Ip-address]
[Subnet-mask]
[Gateway]
G Configure the IP
address of switch
switch(config)#ip address
192.168.1.1 255.255.255.0
192.168.1.254