Ag Leader GPS 1000 Operators Manual - Manual (Page 15)

GPS 1000 Troubleshooting
Ag Leader Technology
April 2001 3000021 13
Troubleshooting The following is a list of problems that you may encounter with the GPS
1000 and suggestions for troubleshooting. If you have a problem with the
system, please review the list before calling Ag Leader Technology. If
your troubleshooting does not solve the problem, please call Technical
Support at Ag Leader Technology (515-232-5363 ext. 1).
Problem Cause Solution
I lose "D" around
buildings when using
WAAS Differential
•
WAAS signal isn't
being transmitted.
•
The WAAS
satellite you are
using is being
blocked.
•
Go to Raytheons website
(wwws.raytheontands.com/waas/)
and check the current status of
WAAS transmission.
•
There are only two (2) WAAS
satellites that are low on the East
and West horizon. Building and
tree lines can easily block the
signal.
I'm connected to the
GPS 1000 but am not
getting position data.
•
Bad Cable or
dirty/wet connector
pins
•
The output settings
of the GPS have
changed.
•
No Power
•
The GPS 1000 is
damaged.
•
Check to make sure the cable isn't
damaged and that the connector is
clean and dry.
•
Connect the GPS 1000 to a PC
using the Aux. Power/Data cable
and run the GPS 1000 utilities
program. Set the outputs to what
is required for your operation.
•
Verify that you are properly
connected to a power source.
•
Call Ag Leader Technical
Support.