HP Linux Server Management Software - Manual (Page 52)

Toolkit utilities 52
ACU scripting error messages
Error code Error message Comment or clarification
1 General error. The ACU process cannot be initiated. You might see this error
message if you are not authenticated to use ACU or if ACU is
already running.
268 Error saving controller. ACU cannot save one or more controller configurations.
278-282 Controller is locked by
another machine or user.
—
290 Error communicating with
controller. —
516 Internal error. An error occurred during the configuration process, but ACU
cannot identify the error because there is an internal ACU error.
1052 Array requires an odd
number of drives. This error message occurs if you attempt to add an odd number
of drives to an array that has RAID 1 logical drives, and the
controller does not support RAID-level migration.
1053 Cannot remove physical
drives from existing array. This error message occurs if a script that is running in
Reconfigure action mode lists fewer physical drives than already
exist in the array. ACU interprets this script as a request to
remove physical drives from an existing array, but satisfying this
request causes data loss, so ACU prevents the script from
running.
1065-1066 Too many coinciding
expansion, migration, or
extension operations.
ACU does not support multiple simultaneous expansions,
migrations, or extensions without saving the configuration
between operations. Limit the number of such configuration
changes in the script.
1091 Controller does not support
SSP. —
1093 Controller requires physical
drives to set license keys.
—
1102 Slot information is not
available. You cannot run a script in Input mode on internal controllers that
do not have slot information online. Systems running Microsoft®
Windows® must have the System Management Driver loaded.
1110 Controller does not support
license keys. —
1111 Invalid license key. —
1112 Controller has maximum
number of license keys. —
1114 Controller requires non-failed
physical drives to set license
keys.
—
2564 Controller is locked by
another machine or user. —
2818
Invalid Method. The scripted Method value is not valid.
2819 Invalid Controller. The scripted controller does not match any existing controllers.
2820 Could not detect controller
. —
2821 No controllers detected. This error applies to Input mode only. If no controllers are
detected in Capture mode, the capture file is empty.
2822 Invalid read cache/write
cache ratio.
The specified cache ratio is not supported by either the controller
or the current controller configuration.
2823
Invalid rebuild priority. —