Control category, Action mode – HP Linux Server Management Software User Manual
Page 43
Toolkit utilities 43
Category
Options
Description
Controller
Controller
ChassisName
ClearConfigurationWithDataLoss
DeleteLicenseKey
DPOEnable
ElevatorSortEnable
ExpandPriority
IRPEnable
LicenseKey
MNPDelay
PreferredPathMode
QueueDepth
ReadCache
RebuildPriority
SSPState
SurfaceScanDelay
WriteCache
Options in this category specify the controller that is to be
configured (or the controller that had its configuration
captured). Although the Controller option must begin this
section of the script, you can script other options in this
category in any order.
You can use one script file to configure all controllers in a
system, and you can configure the controllers identically
or individually. If you define each controller configuration
individually, enter the option values for one controller
and its arrays and logical drives before specifying the
option values for another controller.
Array
Array
Drive
DriveType
OnlineSpare
These options describe an array that is to be configured
on the controller that was previously specified in the
script. (If no controller was previously specified, ACU
stops processing the script and creates an error file.)
Although the Array option must begin this section of the
script, you can script the other options in this category in
any order.
Logical Drive ArrayAccelerator
LogicalDrive
LogicalDriveSSPState
ParityGroups
PreferredPath
RAID
Sectors
Size
SSPAdaptersWithAccess
StripeSize
These options describe a logical drive that is to be
configured on an array that was previously specified in
the script. (If no array was previously specified, ACU
stops processing the script and creates an error file.)
Although the LogicalDrive option must begin this section
of the script, you can script the other options in this
category in any order.
HBA
ConnectionName
HBA_WW_ID
HostMode
These options specify an HBA that is to be configured.
Control category
The Control category has the following options:
•
•
Action mode
You must specify an Action mode:
•
In Configure mode, you can create new arrays, but you cannot modify existing arrays. The controller
must be connected to unassigned physical drives for this mode to be available.
•
In Reconfigure mode, you can modify existing arrays. For example, you can set up an array expansion,
a logical drive extension, or a migration. These procedures do not destroy data, unless you specifically