Changing options for logical – HP StorageWorks XP Remote Web Console Software User Manual
Page 149
TheAdd DKC window shows the following:
•
S/N: Enter the five-digit serial number of the remote storage system.
•
LDKC: Enter the LDKC number of the remote storage system. Enter 00 when the remote storage
system is an XP12000/XP10000 Disk Array or USP V/VM.
Note: LDKC#01 cannot be used in this version.
•
Controller ID: Enter the controller ID (model name that indicates the model) of the remote
storage system.
The controller ID for an XP24000/XP20000 Disk Array is 5.
•
Path Gr. ID: Enter the path group ID. Path group IDs are used for identifying groups of logical
paths. One path group can contain up to eight logical paths.
Path group IDs are within the range of 0-FF (hexadecimal). If you select the Default check box,
the default path group ID will be set.
Note: In the current version, you cannot enter path group IDs. Also, you cannot clear the
Default check box. The number of path groups per one remote storage system is always 1.
•
M-R Path: Specify logical paths from initiator ports on the local storage system to RCU target
ports on the remote storage system.
◦
Port: Displays a list of initiator ports on the local storage system. Select an initiator port
from this drop-down list.
◦
Pair-Port: Displays a list of all ports on the remote storage system. Select an RCU target
port on the remote storage system from this drop-down list.
When specifying a port, you can use the keyboard to enter the port number. When you enter
the port number, you can abbreviate the port number to two characters. For example, you
can enter 1A instead of CL1-A. You can use uppercase and lowercase letters.
•
Option: Opens the DKC Option window (see
“Changing Options for Logical Paths and Storage
).
•
Cancel: Cancels the settings you made on theAdd DKC window and closes the window.
Changing Options for Logical Paths and Storage Systems
Use the DKC Option window (see
) to set the logical path options and storage
system options. These options will apply to the local storage system and the corresponding remote
storage system.
Note: XP Continuous Access Journal windows use the word DKC to indicate a storage system.
To change logical path options and storage system options, follow the described in this section.
The primary storage system administrator and the secondary storage system administrator can
perform this operation.
1.
Ensure that the Remote Web Console main window is in Modify mode.
For detailed information about how to do this, see the HP StorageWorks XP24000/XP20000
Remote Web Console User Guide.
2.
Ensure that the DKC Operation window is open (see
“DKC Operation Window” (page 130)
).
3.
In Display, select DKC.
4.
Select LDKC from the tree.
The list shows remote storage systems.
5.
From the list, select and right-click the desired remote storage system, then select DKC Operation
and Change DKC Option.
6.
On the DKC Option window (
), change the options as desired. For detailed
information about the options, see the explanations below
.
Changing Options for Logical Paths and Storage Systems
149