HP Surestore 2.15 Tape Library - Manual (Page 86)

4-36
Library Operation
Using Online Repair
6. Press NEXT until DRV # OFF FAILED displays then press ENTER .
7. CHANGE CONFIRMED displays briefly, then ONLINE REPAIR*
displays. Press ENTER .
8. DRIVE POWER* displays.
9. Press NEXT or PREV until DRIVE STATUS displays, then press ENTER .
10. Press NEXT or PREV until DRV # OFF FAILED displays (where “#” is the
number of the drive that was just taken offline) then press ENTER .
11. DRV # OFF FAILED displays, where “#” is the drive number and “OFF
FAILED” is flashing.
12. Press NEXT until DRV # ON GOOD displays, then press ENTER .
13. SETTING UP DRIVE displays briefly while the drive communication
tests run, then CHANGE CONFIRMED displays briefly, then ONLINE
REPAIR* displays.
14. Press CANCEL twice to return to the drive numbers and status indicators
(“ready” state).
15. Try reading the damaged tape again.
• If the tape can be read, back up data from the damaged cartridge to
another tape cartridge and discard the damaged one.
• If the tape cannot be read, call a service representative.