HP Surestore 2.15 Tape Library - Manual (Page 74)

4-24
Library Operation
Setting Configuration Options
Setting Configuration Options
1 2 ➞ ADMIN* ➞ PSWD 000 000 000 ➞ CONFIG*
Set certain options, called configurations, to customize the way the library
operates.
To change a configuration:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN* displays, then press ENTER .
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4. INFO* displays. Press NEXT until CONFIG* displays, then press ENTER .
5. Press NEXT or PREV until the name of the configuration to set displays,
then press ENTER . If the configuration has multiple settings, the current
setting flashes. Otherwise, the configuration option is set and a
confirmation message displays. (Configuration options are described on
the following pages.)
If the current configuration setting is flashing, press NEXT or PREV until
the desired setting displays, then press ENTER . OPTION SAVED displays.
6. Press CANCEL to return to the drive status (“ready” state).