HP Surestore 2.15 Tape Library - Manual (Page 81)

4-31
Library Operation
Running an Internal Test
L
ib
r
ar
y
O
p
er
at
io
n
Running an Internal Test
1 2 ➞ ADMIN* ➞ PSWD 000 000 000 ➞ TEST*
WARNING Class II laser light is generated in this library. If operating the library
with access panels removed or with less than three tape magazines
installed with the interlocks disabled and the front door open, do not
stare into the light from the bar code reader.
Laser light warning labels are located adjacent to the side access
panels and the top access panel.
CAUTION Some diagnostic tests, such as Exchange Demo, may place tape cartridges in
unexpected locations, which can cause problems with the software
application being used.
NOTE Some diagnostic tests can only be run through the SCSI interface. Refer to
Digital Linear Tape Drive and Library SCSI-2 Command Reference
(HP
part number 5960-7674) for information about these tests.
To run self-diagnostic tests:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN* displays, then press ENTER .
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4. INFO* displays. Press NEXT or PREV until TEST* displays, then press
ENTER .
5. Press NEXT until test to run displays, then press ENTER .
6. NUM LOOPS # , where “#” is flashing and represents the number of test
cycles the test will go through.
7. Press NEXT to specify the number of cycles, then press ENTER to start the
test.
NOTE Press CANCEL at any time to abort a test. TEST CANCEL - WAIT displays
while the current test loop completes.