HP Surestore 2.15 Tape Library - Manual (Page 38)

2-12
Library Installation
Step 6: Connect Library to Host
6. Carefully route the cables down along the back rail. Use a cable tie to
secure them to the rail just above the slide mounting bracket. Clip off the
ends of all four cable ties.
Figure 2-4 Secured SCSI and Power Cables
7. Close the back door on the rack.
8. Push the library back into the rack.
9. Open the front access door. Replace the two screws that secure the
library to the rack, then relock the door.
Figure 2-5 Front Access Door